Instruction Manual

3|Page
Installation
Parts included: 1 unit with lamp, power cord,
3 screws.
Tools required: Power drill, 2 inch metal
cutting hole saw, screwdriver.
1. Mark your location for mounting the
mounting plate and drill a hole using a 2
inch hole saw.
2. Using screws provided afx mounting
plate to duct
3. Attach the lamp to the lamp holder by
steering the 4 pins into the four holes.
Push lamp tabs in and press the lamp in.
Ensure lamp is locked into position.
4. Line up arrows on lamp holder & mounting
plate and carefully insert lamp & lamp
holder into duct.
5. Once inserted, with the palm of your hand
push and turn lamp holder clockwise so
that it locks into place.
6. Insert power cord into lamp holder and
plug other end into a 120-240V, 50-60Hz.
outlet. A blue LED will illuminate to show
“power on”.
1
2
3
4
Maintenance
WE RECOMMEND EVERY 3-5 MONTHS YOU WIPE
THE UV LAMP DOWN WITH A SOFT CLOTH.
To clean your lamp:
1. Remove power cord from side of unit and allow lamp to cool for a few
minutes before proceeding.
2. With the palm of your hand gently push in and rotate the lamp holder
counterclockwise to line up the two arrows.
3. Carefully remove the lamp holder from duct. CAUTION: Lamp may be hot.
4. Using a soft cloth, carefully wipe the lamp glass and return lamp to the
mounting plate.