Installation Instructions

99-9043-000
99-9043-000
4 5
5. Screw brackets into place with screwdriver.
6. Hook headrail on front of brackets as shown.
Press headrail back until secure.
7. Pull wand along headrail, fully extending panel
glides. Starting at the right side, attach one
shade panel to the velcro on each glide.
1. Remove wand from the left most glide and
re-attach to the right most glide.
2. Loosen screw behind far right glide connector
until glide moves freely. Tighten screw behind far
left glide connector until glide does not move.
OPTIONAL: REVERSE DRAW
This panel track shade comes standard with a Left Draw. If you would like to reverse this and
make this shade a Right Draw, please follow the instructions below.
3
4
5
Click!
Side View
6
7
1
2
6. Pull wand along headrail, fully extending
panel glides. Starting at the right side, attach
one shade panel to the velcro on each glide.
6
1. Center headrail over window, with the top of
the headrail sitting a minimum of 85 inches from
floor or sill. Mark at each end and ensure level.
2. Measure in and mark 3 inches in from each
mark made in Step 1.
3. Align brackets with marks made in Step 2.
Mark screw holes. Space additional brackets
evenly and ensure level.
4. Drill pilot holes at each mark made in Step 3:
For drilling into wood:
Drill at each mark with the 3/32” drill bit.
For drilling into drywall:
Drill at each mark with the 7/32” drill bit.
Insert drywall anchors.
OUTSIDE MOUNT (For inside/ceiling mount, refer back to page 3).
≥ 85"
1
2
3"