Installation Instructions

99-9043-000
99-9043-000
6 3
1. Remove clips from mounting brackets.
2. Measure 3 inches in from each side of
the window and mark clip locations. Space
additional clips evenly.
NOTE: Screw holes should be marked at least
1¼ inches away from the inside edge of the
window frame.
3. Drill pilot holes at each mark made in Step 2:
For drilling into wood:
Drill at each mark with the 3/32” drill bit.
For drilling into drywall:
Drill at each mark with the 7/32” drill bit.
Insert drywall anchors.
4. Place spacers on top of clips and screw
brackets into place with screwdriver.
5. Hook headrail on front of brackets as shown.
Press headrail back until secure.
1. Mark 1” below desired length on hanging panel.
2. Remove panel from glide.
3. Lay panel out fully on flat surface. Remove bottomrail using allen
wrench.
4. Cut marked panel with shears.
5. Using shortened panel as a guide, mark and cut remaining panels.
6. Re-attach bottomrail to each panel by wrapping fabric around
bottomail insert, then sliding insert into bottomrail. Tighten with allen
wrench.
7. Starting at the right side, re-attach one shade panel to each glide.
4
Click!
Side View
5
6
7
5
1¼"
3"
2
3
1
INSIDE/CEILING MOUNT (For outside mount, skip to page 4).OPTIONAL: SHORTEN PANELS
1
2
3
4