Software

xMAP Technology Troubleshooting
PN 89-00002-00-150 Rev. A 8 - 5
Sample Probe Problems with the sample probe can lead to fluid leaks and
pressurization problems, as well as inhibit sample acquisition.
The sample 3-way valve is
faulty.
Contact Technical Support.
Fluid leaking from front of
analyzer
The syringe seal leaks. Replace the syringe seal.
The syringe valve leaks. Hand-tighten the syringe
connection (silver knob) to the
white syringe valve. Run a
Prime. If leaks continue, contact
Technical Support.
Symptom Possible Problem Solution
Sample probe leak The sample probe is clogged. Clean the sample probe. See
page 7-4.
Sample arm stuck in the up
position
The system isn’t properly
pressurized.
If a PRESSURIZATION error
message displays, see
Pressurization on page 8-3.