User Manual, Version 2.3

xMAP Technology Using Luminex 100 IS 2.3 Software
PN 89-00002-00-071 Rev. C 5 - 67
6. Click the Bead Set tab. Select the checkboxes next to each
desired bead set for this batch. Click Select All to select all the
listed bead sets, or Deselect All to deselect all selected bead sets.
Figure 5-36. Options Dialog Box—Bead Set Tab
7. Edit the Events and Caption information for each bead set. Edit
the Default Events box to change the default value. Click Apply
to All to apply the default value to all bead sets. Table 5-8 lists
selection shortcuts.
8. Click the Plate Layout tab. See Figure 5-37. On this tab you
define commands for the desired wells on the plate. You can
Table 5-8. Bead Set Tab - Selection Shortcuts
Selected Column Select by clicking in the box.
Events Column Select desired field and right-click.
The value displayed in the “Default
Events” box updates the selected field
when you click “Apply Default”.
Caption Column If names are defined under this
column, you can right-click selected
rows and “Reset” back to normal
defaults.
Entire Column Select an entire column by clicking
the column heading (Selected,
Events, or Caption).
Table 5-9. Symbol
Color Codes
Symbol Color
A
C1
C2
N1
N2
W
D
S
Blue
Red
Green
Teal
Purple
Olive
Black
Fuchsia
Note: The legend at the left
side of the tab (No, Cmd
Name, and Symbol columns)
shows available commands
and their colored-coded sym-
bols. Symbol appears in the