Installation & Assembly

INSTALLATION INSTRUCTIONS

ELECTRIAL SHOCK HAZARD

READ, UNDERSTAND, and FOLLOW these instructions

before installing the equipment.

WARNING

SAFETY

INSTALLATION

TRUNNION MOUNTING

Disconnect the Electrical supply power at the service panel (fuse or circuit breaker box). Failure to do so could result in serious

injury or death. Only qualified electricians should install this fixture and the installation MUST conform to the National Electrical

Code Part I and all local codes and ordinances. Ensure that only proper tools, materials, and equipment are used to complete

the installation.

• Proper grounding is required to ensure personal safety

• Servicing this equipment should be performed by qualified service personnel.

• Save these instructions

UL and C-UL listed or CSA certified liquid tight cord grip is suitable for use with STW

flexible cord and shall be used for connection to a wet location outlet box provided

by others.

To adjust the angle of the fixture using the trunnion:

• Loosen the Pivot Bolts & angle locking screw.

• Adjust fixture to desired angle.

• Tighten Pivot Bolts & angle locking screw.

CAUTION

Please see back for wiring instructions and troubleshooting.

SLIP FITTER

• Connect the wires properly in the post.See wiring diagram.

• Loosen the locking screws from the slip fitter.

• Secure the fixture to post by screwing the locking screws.

• Loosen the screw on swivel portion of the slip fitter,adjust the fixture to a suitable

orientation and then tighten the screw.

WALL MOUNTING

• loosen the screws to open the connection box cover(wall mount plate),drill the holes

in the area of the installing holes.

• Pass the wires through waterproof joint to the wall mount plate and use the water

proof joint to tighten the wires.

• Attach the wall mount plate to the wall.

• connect the wires properly in the connection box and screw the wall mount plate

tighten.

• Loosen the screw on swivel portion of the wall bracket,adjust the fixture to a suitable

orientation and then tighten the screw.

PAGE 1
IN STALLAT I O N INS T RU C T I ON S E L E CTRIA L SH OC K H A ZA RD READ, UNDERSTAND, and FOLLOW these instructions before installing the equipment. WA R N I N G Disconnect the Electrical supply power at the service panel (fuse or circuit breaker box). Failure to do so could result in serious injury or death. Only qualified electricians should install this fixture and the installation MUST conform to the National Electrical Code Part I and all local codes and ordinances.
PAGE 2
WI R I NG ON-OFF WIRING METHOD: Universal voltage driver permits operation at 120V through 277V, 50 or 60 Hz. Units ordered with (480V) suffix are 480V, 60Hz. For Non-Dimming, follow the wiring directions as in FIG. 1 1. Connect the GROUND wire from fixture to supply ground 2. Connect the white fixture lead to the (-) COMMON supply lead 3. Connect the black fixture lead to the (+) LINE supply lead 0-10V DIMMABLE WIRING METHOD: Universal voltage driver permits operation at 120V through 277V, 50 or 60 Hz.