Instructions / Assembly

DRAPERY ROD SET INSTALLATION INSTRUCTIONS
Double Rod Conversion Kit Length 50 in.-144 in.
Safety Information
WARNING: Product failure due to using incorrect fittings is
responsibility of the installer.
CAUTION: Before installing brackets, always check there are
no hidden wires or pipes.
To remove dust, use a vacuum cleaner with a brush attachment end and
gently rub using a water-dampened cloth with a mild detergent only.
CARE AND CLEANING
TOOLS REQUIRED
Tape Measure Level
Philips-head
screwdriver
Drill and Bit SetPencil
A
B
C
Part Description Quantity
Finials 2
Outer rods
(larger diameter)
2
Inner rod
(smaller diameter)
1
D
E
F
Part Description Quantity
Brackets
3
Screw-in anchors 6
Screws 6
PACKAGE CONTENTS
A
DDD
B C B
A
E
F
2A
Mounting to drywall or paneling
Pre-drill two pilot holes per bracket using 1/4 in. bit. Drill
horizontally without forcing drill or enlarging the hole.
Screw anchors (E) into pilot holes. To install brackets
(D), fasten the screws (F) into the anchors (E).
3B
Total desired rod length ≥ 97 in.
For desired total rod length more than 97 in. the extra outer rod
(B) provided is required. Unfasten finial (A) out of inner rod (C).
Remove disposable caps from extra outer rod (B) and fasten
finial (A) on its end. Feed one sheer drapery panel onto 2-piece
telescopic rod (B & C) and a second sheer drapery panel onto
extra outer rod (B). Insert inner rod (C) into extra outer rod (B)
to form a 3-piece telescopic rod (B & C) that can extend up to
144 in.
2B
Mounting directly to wood or studs
Pre-drill two pilot holes per bracket using 3/32 in. bit.
Drill horizontally without forcing drill or enlarging hole.
To install brackets (D), fasten screws (F) into pilot holes.
3A
Total desired rod length < 97 in.
For desired total rod length less than 97 in. only a
2-PIECE telescopic rod (B & C) is needed; the extra outer
rod (B) provided can be discarded. Unfasten finial (A) out
of inner rod (C), feed drapery panels onto telescopic rod
(B & C), and fasten finial (A) back into inner rod (C).
1
Place brackets (D) against wall at desired locations and mark
screw holes. Use tape measure and level to ensure marked
screw holes are aligned.
Before bracket installation
INSTALLATION
Retain this manual for future use.
4
Extend telescopic rod (B & C) to desired width and place it into inner
cavities of brackets (D), leaving space in between drapery panels for
center bracket. Secure telescopic rod (B & C) by tightening the
screws in the brackets (D). This prevents the telescopic rod (B & C)
from moving. To hang second set of drapes, repeat steps 3 to 4 with
an additional rod (not included) and place it into outer cavities of
brackets (D).
Final adjustment
Pre-Installation
NOTICE: The finials shown are for illustration purposes only. It may not represent the style of finial purchased.
For larger width windows, two people may be required for easier installation.
B C
A
CAPCAP
EXTRA OUTER ROD
B
C
A
D
A
A
B C B
Inner cavity
Outer cavity
DRYWALL
F E
D
WOOD
or
STUDS
F
D