Product Manual

ManualsBrandsLumex ManualsBed Rails/Patient Assist BarsUniversal Half Side Rail

GF6650A-1-INS-LAB-RevC08

GF6650A-1: HomecAre clAmp-on HAlF rAil

instAllAtion & operAtion instrUctions

pleAse sAVe tHese instrUctions For FUtUre Use

Note: The most current version of these instructions can be found online at www.grahamﬁeld.com

WARNING: Important! Read and understand these instructions before installing or using

the GF6650A-1 Homecare Clamp-On Half Rail. If you do not understand any part of these

warnings, cautions or instructions, contact a healthcare professional for direction in the

use of this product. If the Homecare Clamp-On Half Rail is not properly installed and ad-

justed, personal injury and damage to the half rail could result.

For information on Bed Rail safety, please see the following brochure: "A Guide to Bed

Safety: Bed Rails in Hospitals, Nursing Homes and Home Health Care: The Facts" on the

FDA website, at http://www.fda.gov/cdrh/beds/

WARNING: The Homecare Clamp-On Half Rail is designed for use in the homecare set-

ting. The Homecare Clamp-On Half Rail is not intended for institutional use.

WARNING: If components are damaged or missing, contact your dealer immediately. DO

NOT use substitute parts. Use only Lumex replacement parts. Non-Lumex replacement

parts could cause entrapment, personal injury, and damage to the half rail.

WARNING: The Homecare Clamp-On Half Rail is intended to dene the edge of the sleep

surface and to help prevent an individual from inadvertently rolling out of bed. DO NOT

use the half rail as a restraint.

WARNING: Although it has no specic weight limitation, the Homecare Clamp-On Half

Rail may deform or break when subjected to excessive side pressure.

DO NOT exert side pressure on the half rail.

DO NOT use it as a handle for getting into or out of bed.

DO NOT use it as a push handle for moving the bed.

DO NOT use it as an aid in transfer.

These activities could result in personal injury and damage to the half rail.

WARNING: GF Health Products, Inc. assumes no responsibility for any damage or injury

caused by improper installation or use of this product.

INSTALLATION

Movable clamp

disassembly

The Homecare Clamp-On

Half Rail, as shipped, is

shown at near right. Be-

fore installation, you must

disassemble the movable

clamp.

Unscrew the knob from the movable clamp assembly to separate the knob,

spacer, and threaded clamp, as shown at far right.

homecare clamp-on half rail and

movable clamp as shipped

homecare

clamp-on

half rail

mounting

slot

retainer bar

movable

clamp

retainer hook

disassemble

clamp

knob

spacer

clamp

Summary of content (2 pages)

PAGE 1
GF6650A-1: Homecare Clamp-On Half Rail Installation & OPERATION INSTRUCTIONS PLEASE SAVE THESE INSTRUCTIONS FOR FUTURE USE Note: The most current version of these instructions can be found online at www.grahamfield.com WARNING: Important! Read and understand these instructions before installing or using the GF6650A-1 Homecare Clamp-On Half Rail. If you do not understand any part of these warnings, cautions or instructions, contact a healthcare professional for direction in the use of this product.
PAGE 2
Homecare Clamp-On Half Rail installation Note: The Homecare Clamp-On Half Rail may be installed on either head deck angle or foot deck angle. The Homecare Clamp-On Half Rail CAN NOT be installed on pan deck. 1. Attach movable clamp jaw over deck movable angle, with threaded rod facing outclamp jaw ward, as shown at near right. deck angle 2. Position half rail with fixed clamp jaw toward bed and rails facing outward, as shown at far right.