Product Manual

8 B700-INS-LAB-RevC10
5 ASSEMBLYINSTRUCTIONS
WARNING: Becausethebedisveryheavy,bedassemblyrequirestwopeople.
ASSEMBLINGTHEHEADANDFOOTSECTIONS
Tools required: two
9
/16″ wrenches
HEAD
SECTION
FOOT
SECTION
head motor tube
1. Lay the bed’s foot section (with motors and junction box) upside down, at on the oor, as
shown above. Do the same with the head section close by.
FOOT
SECTION
HEAD
SECTION
head section rivet
foot section hook
move the head motor tube
slightly over to left or right
for easier assembly
2. Move the head motor tube slightly over to the right or left to get it out of the way. Using two
people, lift the head section so that it stands perpendicular to the foot section as shown
above. Lift the head section and align the two rivets (on either side of the inside frame) with
the two hooks in the foot section frame, as shown above. Lower and slowly maneuver the
head deck so that the rivets seat in the hooks.
WARNING:TherivetsMUSTbeproperlyseatedinthehooks,otherwiseper-
sonalinjuryand/orpropertydamagecouldoccur.