Product Manual

14 B700-INS-LAB-RevC10
FOOT
SECTION
3. Once the rivets are aligned with the hooks, tilt the bed end forward, toward the foot section
as shown above, then lower the bed into the hooks to lock into place. Do the same for the
head end of the bed, repeating steps 2 and 3.
InstallingtheBedEndLockingHardware
WARNING:Ensuretheclevispins,washers,andhairpinclips,whichactas
latches,areproperlyinstalledtoavoidpersonalinjuryorpropertydamage.
4. Once you have the head and foot bed ends installed on
the bed with the rivets resting securely in the hooks as
shown at right, reinstall the locking hardware on all four
corners to lock them into place.
5. Slip a fender washer onto the exposed end of each clevis
pin. From the outside, insert the two clevis pins with
washers (that you removed in step 1) through the holes
on both sides of the foot section’s rivet plates as shown
at right. The fender washers will rest on the outside of the
bed end’s hook plates as shown.
6. From the inside, insert a hair pin clip into the small hole
at the end of each clevis pin.
7. Follow the same procedure for the head bed end section.
bed end
hook plate
foot section
rivet plate
clevis pin
fender washer