Product Manual

B700-INS-LAB-RevC10 13
INSTALLINGTHEHEADANDFOOTBEDENDS
RemovingtheBedEndLockingHardware
hair pin clip
rivet plate
clevis pin
fender washer
1. You must rst remove the bed end locking hardware (clevis pins, washers, and hair pin
clips, total 4 each) from the frame rivet plates on both sides of the bed before you can at-
tach the bed ends. The bed end locking hardware has been pre-installed at the factory for
ease of shipment, and will be reinstalled after installing the bed ends to act as latches when
the bed ends are attached to head and foot sections.
InstallingtheBedEndsontheBed
WARNING:Becausethebedisheavy,bedendassemblyrequirestwopeople.
FOOT
SECTION
foot bed end
foot section
end rivet
bed end hook
2. Position the bed on the oor, resting on the motor guards with deck on top, as shown
above. Position the foot bed end assembly near the bed so that the hooks face toward the
foot section as shown. With a person on each side, carefully lift the foot section at an angle
and ease the two foot section end rivets into the bed end hooks on both sides of the foot
bed end. You may need to tilt the bed end backward slightly, away from the foot section as
shown above, in order to maneuver the rivets into both hooks.