Product Manual

10 B700-INS-LAB-RevC10
FOOT
SECTION
HEAD
SECTION
position side brace end slot large
ends over bed frame shoulder bolts,
then slide small slot ends up to trap
bolts, on both sides of the bed
side brace
vertical
link
4. Position the truss assemblies on both sides of the bed so that the vertical truss links face
the middle of the bed and the side braces are on the outside. Position the side brace end
slot large ends over the protruding welded shoulder bolts near the ends of both the head
and foot section frames, then slide the small slot ends over the shoulder bolts so that the
bolts are trapped in the small slot ends, as shown above.
motor guard
truss assembly vertical link
bolt, truss assembly vertical link
locking nut, truss assembly vertical link
5. Attach the truss assembly vertical link to the main frame. Remove the nut from the bolt at
the end of the vertical link as shown above. From the outside of the main frame, insert the
bolt (with link) through the central hole. From the inside of the frame, secure the bolt using
the same locking nut you removed earlier. Tighten both the bolt and the nut using two
9
/16"
wrenches. Repeat for other side.
6. Once the truss assemblies are securely installed, carefully turn the bed over so that it rests
on the motor guards.