Users Manual

English -
29
Chapter 10 Troubleshooting
This cha p ter describes p roblems you may encounter while using DC-W80. If you
have q uestio n s, please refer to related chapters and follow all the suggested
solutions. If the problem still occurred, please contact your distributor or the
service center.
No. Problems Solutions
1 Boot without
power signal
Please press the battery level check button to
confirm there is still power. Refer to 3.4
Description of LED indicator in this manual. If
there is no power left, please charge the device by
connecting the USB cable.
2 There is no
image output
from DC-W80
1. Check the power.
2. Check all cable connections. Refer to Chapter 4
Installation and Connections in this manual.
3. Check if DIP switch is properly set. Please refer
to Chapter 9 DIP Switch Setting
for related
settings.
3 Unable to focus Probably the document is too close. Press [ZOOM
-] on the control panel. Or pull the document away
from the lens. And then press [Auto Focus] butt on.
4 When the
device is turned
on, the LED
floodlight is off.
The default setting of the LED floodlight is “OFF”,
please use the control panel to set the LED
floodlight as “ON”.
5Ladibug™ and
other
applications
cannot be used
simultaneously
Ladibug™ and other applications cannot be used
simultaneously. Only one application can be
executed at a time. Please close the currently
running applications and then execute the
application to be used.
6 The output
image is too
bright, too dark,
or vague.
Press [AUTO TUNE] button to automatically adjust
the image to have the best brightness and focusing
performance.
7 The operating
steps in the
manual are not
applicable to the
machine.
The operating steps in the manual may be not
applicable to the machine due to improvement in
functions.
Please confirm the firmware of your machine and
go to check for any updated version on the Lumens