Full Product Manual

Operation Instructions cont’d

Concrete:

4c. Remove the Mounting Bracket to expose the

marks made in step 3 on page 10.

5c. Pre-drill a 1/4” hole at each of the marked

locations.

6c. Insert the Anchors into the drilled holes from

step 5c. You may need to lightly hammer the

Anchors in place.

7c. Place the Mounting Bracket over the Anchors

aligning the Mounting Holes to the Anchors.

8c. Fasten the Lumenology Dual Security Motion

Light to wall with the supplied Screws.

USING CLAMP

1. Slide the threaded end of the L-Rod through the

Clamp (shown left).

2. Thread the Butterﬂy Nut onto the L-Rod by rotating

clockwise. Do not thread all the way down at this

time.

3. Add Plastic Cap to the threaded end of the L-Rod.