Full Product Manual

10
© Limitless Innovations, Inc.
HOW TO INSTALL THE LUMENOLOGY DUAL SECURITY MOTION LIGHT
Operation Instructions cont’d
USING BRACKET
1. Measure, locate, and mark where the Lumenology
Dual Security Motion Light will be installed.
NOTE: It is recommended to install the Lumenology
Dual Security Motion Light directly to a wooden
stud, metal stud or plywood wall sheathing.
2. Place the Mounting Bracket on the spot marked
in step 1.
3. Using a pencil, mark the location through two
of the Mounting Holes as shown.
NOTE: It is recommended to mark the Mounting
Holes that are kitty-corner from each other.
Wood Stud, Metal Stud or Plywood Wall Sheathing:
4a. Fasten the Mounting Bracket directly to the wall
with the included Screws. No additional Anchors
are necessary.
Dry Wall Without Stud:
4b. Remove the Mounting Bracket to expose the
marks made in step 3 above.
5b. Pre-drill a 1/8” hole at each of the marked
locations.
6b. Insert the Anchor into the drilled hole from
step 5b. You may need to lightly hammer the
Anchor in place.
7b. Place the Mounting Bracket over the Anchors
aligning the Mounting Holes to the Anchors.
8b. Fasten the Lumenology Dual Security Motion
Light to wall with the supplied Screws.