Installation Guide
Full product range & more information: www.lumenalights.com
INSTALLATION:
1. Select a suitable “open” mounting position so that the photocell is not affected by the light output of the fitting.
2. Make an 18-20mm diameter hole in the mounting surface ensuring that the hole is free from burrs or rough edges.
3. Remove the nut of the external PC by unscrewing anti-clockwise and lift off the top rubber washer.
4. Install the photocell in the prepared hole from the inside, ensuring that the bottom rubber washer is in place internally
(between the mounting surface and the photocell backing).
5. Fit the top rubber washer to the protruding photocell on the outside of the mounting surface and firmly secure in place
with the nut removed in point 1 by turning clockwise.
6. Wire in the 240v power supply and the fitting to be powered by following the diagram below.
7. Reconnect to the power supply, ensuring all connections are secure and no bare wires are left free of the terminals.
8. Restore the power and test by covering the photocell unit to switch on, waiting one minute, then removing the cover and
checking that the unit has switched off.
IMPORTANT: Mounting this sensor facing the ground, under shelter or where influenced by other lighting,
especially the light of which it is controlling, may affect the functionality of the sensor. Ensure the photocell is not
obstructed or affected by other light.
CLEANING & MAINTENANCE:
Occasional cleaning and care is recommended for this product. Wipe the external PC sensor with a soft, slightly damp cloth to
remove any surface dirt and maintain efficiency. Do not use abrasive cleaners or a lot of water as this could damage the unit. DO
not use any form of liquid around the sensor box as this is not a waterproof component. Please refer to our website for more
information on the best way to clean different materials.
INSTRUCTIONS ACCURATE AT TIME OF PRINTING. CHECK FOR UPDATES ON OUR WEBSITE OR
CONTACT US SHOULD YOU REQUIRE ANY FURTHER ASSISTANCE.
SENSOR
BOX
EXTERNAL
PC
FITTING
240V
POWER
FEED
LIVE IN (BROWN)
NEUTRAL (BLUE)
LIVE OUT (RED)
EARTH (YEL/GRN)