Owner's Manual

FCC STATEMENT:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to Part 15 of the FC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
-English:”
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may cause undesired operation of the device.”
- French:"
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil nedoit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement."
Specification of radio transmission
Product:
Model:
Operating Frequency:
Power:
Lumos Kickstart Helmet Lumos Remote
L1101L LRELRN-AO
2455.5M
Hz
RX 3.7V 800mAH TX 3.7V 90mAH
The above product is in conformity with the PPE Regulation(EU) 2016/425 and is identical to the PPE which is subject of EU certificate LEC FI00369703 issued by ITS Testing Services UK Ltd
The above product is in conformity with the European Radio Equipment Directive (RED) (2014/53/EU) which is subject of EU certificate 172140265/AA/00 issued by Telefication
Bluetooth LE
Maximum Output Power: -1.0 dBm EIRP Average (Calculated)
Maximum Antenna Gain: 1dBi
You can find the declaration of conformity by the following links:
www.lumoshelmet.co/EU_DoC
Company Information:
Lumen Labs (HK) Limited
www.lumoshelmet.co
FOR AUSTRALIA:
CR Kennedy & Company Pty Ltd
300 Lorimer Street, Port Melbourne 3207
P.O. Box 82, Port Melbourne 3207
Victoria, Australia T: [phone]
Address:
25/F, Two Harbour Square
180 Wai Yip Street, Kwun Tong, Hong Kong
Need more help?
Email us at [e-mail]
We would be happy to assist you!