User Manual

03
GENERAL POWER TOOL SAFETY WARNINGS
6.2 Preve nt dust accumulation at the workplace.
Dust can easily ignite.
7 Additional Warnings for Sanders
7.1 Harmful/toxic dusts will arise from sanding
e.g. lead painted surfaces, woods and metals.
Contact with or inhalation of these dusts can
endanger the health of operator and bystanders.
Always u se eye glasses and dust mask.
7.2 Hearing protection should be worn when
using the sander.
7.3 Alwa ys wear safety glasses or eye shields
when using the sander. Everyday eyeglasses
have only impact-resistant lenses; they are not
safet y glasses. Following this rule will reduce the
risk of serious personal injury.
7.4 Rem ove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
7.5 Fully unwind cable drum extensions to
avoid po tential overheating.
8.6 When an extension cable is required you
must en sure it has the correct ampere rating for
your pow er tool and is in a safe electrical
condition.
7.7 Ensur e your mains supply voltage is same as
indicated on the rating plate.
7.8 Your tool is double insulated for additional
protecti on against a possible electrical
insulatio n failure within the tool.
7.9 Always check walls, floors and ceilings to
avoid hid den power cables and pipes.
7.10. Af ter long working period’s external metal
parts and accessories could be hot.
7.11 If p ossible, ensure the work-piece is firmly
clamped to prevent movement.
7.12 Your sander is a hand held tool, do not
clamp y our sander.
7.13 Bef ore sanding, check the area is free of
nails, screws, etc.
7.14 Never stop the sander by applying a force to
the base plate.
7.15 Only use paper in good condition. Do not use
torn or worn paper.
8.16 Do not sand material containing asbestos
due to a health risk.
7.17 Do not sand lead based paint due to the risk
of lead poisoning.
7.18 Do not eat or drink in the working area of
the sander.
7.19 Do not allow people to enter the working
area without wearing a dust mask.
7.20 Where possible, seal off the working area to
contain the dust for later removal.
7.21 Your tool is designed for dry sanding only,
not wet sanding.
7.22 Your tool is designed for general purpose
light polishing of wood and metals.
7.23 Do not sand magnesium material due to the
risk of fire.
VSJ100