User Manual

08
APPLICATIONS
2) Hold saw firmly and tilt it forward so the toe of
the steel base rests on the workpiece. Start the
saw and then gradually lower the blade. When the
blade touches the workpiece, continue pressing
down on the toe of the steel base. Slowly pivot the
saw like a hinge until the blade cuts through and
the base rests flat on the workpiece. Then begin
sawing along the cut line.
3. METAL CUTTING
When cutting metals, ideally an oil grease is
needed. If not, this may shorten the blade
lifespan.
4. PARALLEL GUIDE
This saw can be used with a parallel guide for
quickly straight cutting.
Set the desired cutting width as the scale value
on the inside edge of the base plate.
VSJ100