Product Manual

ALWAYS unplug the drill before adjusting the blades or

adjusting the chuck

● Make sure the tool is square against the end of the log

before cutting

● If the tool is held at an angle the tenon will be cut angled

Cutting Tenons (cont.)

● Carefully install the tenon

cutter into an unplugged 1/2”

drill, and tighten it firmly. Use

the tee handle to tighten the

chuck

● Square up to the log so that

the cutter is flush against the

flat face of the log

● Apply body pressure by leaning

into the drill before starting the

drill

● Pull the trigger to cut the tenon

● Wait until the drill comes to a

stop before removing the

cutter from the log

4.5

CORRECT

Drill in-line with log

WRONG

Drill not in-line with log (crooked)