User guide

Chapter 3
_________________________________________________________________________
________________________________________________________________________
BE6027-12 LumaSoft Gas Software LumaSense Technologies A/S
7810 and 7860 Page 49 of 194
3.2.5 Units
Select Unit in the Set Up drop down menu. (See Figure 3.31)
Figure 3.31 Set Up pull-down: Unit
Figure 3.32 Select in which units the data should be displayed
In this window the user can select in which units Humidity, Pressure,
Gas Concentration, Temperature and Length will be shown. The
Normalization Temperature can also be changed. The normalization
temperature is the reference temperature, for reporting data in absolute
unit mg/m
3
. A normalization temperature of 25°C means that the
measured gas concentrations will be calculated in mg/m
3
at 25°C. The
user can choose between three different normalization temperatures,
see table 3.2.
Display Text
Options
Default
Value
NORMALIZATION TEMPERATURE
0°C, 20°C and 25°C
20°C
NORMALIZATION TEMPERATURE
32°F, 68°F and 77°F
68°F
NORMALIZATION TEMPERATURE
273K, 293K and 298K
293K
Table 3.2 The possible values and the default values of the
normalization temperature