Owner's manual

Chapter 4
_________________________________________________________________________________________
_____________________________________________________________________________
BE6024-12 1316A-3 Multi Gas Monitor LumaSense Technologies A/S
Instruction Manual Page 73 of 96
Connect the SPAN gas to the INLET on the rear panel of the Multi
Gas Monitor INNOVA-1316A-3.
Pull down the Bench Command Menu
And select Span Calibration see figure 4.21.
Figure 4.21. The Bench Command Menu
The following window will appear, see figure 4.22.
Figure 4.22. The Span Calibration window.
Tick the gas(ses) to be Span calibrated, and key in concentration value(s), see
figure 4.23. Press the “Send” button to perform the Span calibration. Observe