Owner's manual

Chapter 4
_________________________________________________________________________________________
_____________________________________________________________________________
BE6024-12 1316A-3 Multi Gas Monitor LumaSense Technologies A/S
Instruction Manual Page 61 of 96
Figure 4.6. Status Window displaying Operation Mode “Start up”.
2. The Multi Gas Monitor – INNOVA is in Stand By mode.
3. A Flow Fault has been detected, see figure 4.4,”Pump Out
Flow” caused by exceeded pressure limits.
4. If the CO
2
, CO, or Ethanol channel gain cannot be set (e.g., the
IR signal is too strong), the following warnings occur, see
figure 4.7.
CO
2
Zero Fail.
CO Zero Fail.
Ethanol Zero Fail