Installation Manual
ADH111689
Customer First Center
1121 Highway 74 South
Peachtree City, GA 30269
P: 770.486.4800 F: 770.486.4801
www.cooperlighting.com
Crosstour
TM
LED
Wire Guard
Sheet 1 of 1
9/22/2011 IMI-768
SAFETY: This fixture must be wired in accordance with the National Electrical Code
and applicable local codes and ordinances. Proper grounding is required to insure
personal safety. Carefully observe grounding procedure under installation section.
WARNING: Make certain power is OFF before starting installation or attempting any
maintenance. Risk of fire/electric shock. If not qualified, consult an electrician.
• RISK OF ELECTRIC SHOCK—Disconnect power at fuse or circuit breaker before
installing or servicing.
• RISK OF BURN—Disconnect power and allow xture to cool before servicing.
• RISK OF PERSONAL INJURY—Fixture may become damaged and/or unstable if not
installed properly.
• DO NOT mount luminaire within 6" of a combustible surface. DO NOT handle
luminaire by the glass.
INSTALLATION INSTRUCTIONS
IMPORTANT: READ BEFORE INSTALLING FIXTURE.
RETAIN FOR FUTURE REFERENCE.
WARNING: Make certain power is OFF before starting installation or attempting any maintenance.
These instructions do not claim to cover all details or variations in the equipment, procedure, or process described, nor to provide directions for meeting every possible
contingency during installation, operation or maintenance. When additional information is desired to satisfy a problem not covered sufciently for user’s purpose, please contact
your nearest representative. NOTE: Specications and dimensions subject to change without notice.
TOOLS REQUIRED: Phillips head screw driver and electrical wiring tools.
1. Install Crosstour luminaire to wall.
2. Orient wire guard over the luminaire so the open slot is aligned with the lens.
3. Use #8 fasteners (supplied by others) to attach wire guard to the mounting surface.