Cut Sheet

VOLTAGE CHART
120/208/240/277 (wired 277V)
120/277/347 (wired 347V)
MT=Multi-Tap
TT=Triple-Tap
120/208/240/277/480 (wired 277V)
5T=5-Tap
9
Metal Halide (MH) 175, 250, 400W
High Pressure Sodium (HP) 250, 400W
Pulse Start Metal Halide (MP) 175, 200, 250, 320, 350, 400, 450W
LAMP TYPE
WATTAGE
ADH082398
2015
-12-02 11:13:08
ORDERING INFORMATION
Sample Number: MPSS-ER22-C-175-120V-OR
Lamp
Wattage
MP
175
175W=
200
200W=
250
250W=
320
320W
=
400
400W
=
450
450W
=
MH
2
175
175W
=
250
250W
=
400
400W
=
HP
250
250W
=
400
400W
=
Accessories
C3
3' Cord-No Plug - Requires FH-1,
FL-1, or SHK
10
=
PC3
3' Cord with NEMA Plug - (120V-L5,
208V-L6-15P, 347V-L37-20P and
480V-L8-20P) Other cord lengths
are available by specifying length
(PC6 for 6' cord). Requires FH-1 or
FL-1, or SHK. Use with
TPPH-NEMA. Specify Voltage.
10
=
PHC
Power Hook Cord and Non-NEMA
plug configuration. Must be used with
FL-1 and TPPH (Thru-Way Pendant
Power Hook)
=
PHC-NEMA
Power Cord and NEMA plug -
18" Power Cord and 20 Amp
NEMA plug configuration.
Must be used with FL-1 and
TPPH-NEMA (Thru-Way
Pendant Power Hook)
=
SGB22A
(Not Compatible with WG22 -
400W max.)
=
WG22/GLC
Gym Wireguard w/ Safety
Glass
=
WG22
Wire Guard for AC22 or PD 22"
Refractor (Not compatible with SGB)
=
DB22
Drop Acrylic for 22" refractor
(400W max.)
=
CB12
Conical Bottom Lens for 12"
Refractor
=
CB16
Conical Bottom Lens for 16"
Refractor
=
MBT
Twin Mount Bracket (Fixtures must
be same voltage and without hooks,
loops or plugs.)
14
=
TPPH
Thru-Way Pendant Power Hook.
Requires FL-1 and PHC. Specify
Voltage.
=
TPPH-F
Thru-Way Pendant Power Hook
Single Fuse, 120, 277 or 347 Volt.
Requires FL-1 and PHC. Specify
Voltage.
=
TPPH-F2
Thru-Way Pendant Power Hook -
Double Fused, 208, 240, or 480
Volt. Requires FL-1 and PHC.
Specify Voltage.
=
TPPH-F-QD
Thru-Way Pendant Power
Hook Single Fuse, Quick
Disconnect. Requires FL-1
and PHC. Specify Voltage
(120, 277, or 347V)
=
TPPH-F2-QD
Thru-Way Pendant Power
Hook Double Fuse, Quick
Disconnect. Requires FL-1
and PHC. Specify Voltage
(208, 240, or 480V)
=
TPPH-NEMA
Thru-Way Pendant Power
Hook. Requires FL-1 and
PHC-XXXV-NEMA. (Specify
Voltage).
=
FH-1
Fixture Hook
=
FL-1
Fixture Loop
=
SHK
Hook with Safety Screw
=
TWMBS
Thru-Way Mounting Box
15, 15
=
Options
C3
3' Cord with no plug (Specify Voltage)
10
=
PC3
3' Cord with NEMA Plug (120V-L5-15P,
208V-L6-15P, 347V-L37-20P, AND
480V-L8-20P) Other cord lengths are
available by specifying length (PC6 for
6' Cord) Requires FH-1 or FL-1, or
SHK. Example: PC3-120V Use with
TPPH-NEMA. Specify Voltage.
10
=
PHC
Power Cord and Plug (18" Power Cord
and Non-NEMA plug configuration. Must
be used with FL-1 and TPPH (Thru-Way
Pendant Power Hook). Must specify
single voltage.
=
PHC-NEMA
Power Cord and NEMA Plug (18"
Power Cord and 20 AMP NEMA
plug configuration). Must be
used with FL-1 and TPPH-NEMA
(Thru-Way Pendant Power
Hook).
=
P
Pre-set Socket Position from the factory
=
FH-1
Die-cast Aluminum Fixture Hook (with
3/4" threads for easy installation)
=
FL-1
Malleable Iron Plated Fixture Loop (with
3/4" threads for easy installation)
=
SHK
Die-cast Aluminum Fixture Hook (with
safety screw and 3/4" threads for easy
installation)
=
HSW
Integral LumaWatt Sensor and Control
w/ Wide Distribution
11
=
F1
Single Fuse (120, 277 or 347V only)=
F2
Double Fuse (208, 240 or 480V only)=
SCF
3' Aircraft Safety Cable secures
Housing to Ceiling (Alternative lengths
available. Example: SCF6 = 6' Cable)
=
Q
Quartz Restrike (Hot Strike Only)=
EM
Quartz Restrike with ''Delay Relay'' (Quartz
lamp strikes at both hot and cold starts)
=
EM/SC
Emergency Separate Circuit
12
=
L/TCB
Less Top Connector Box (Housing
shipped less top connector box.
(Specify when using TWMBS
accessory)
=
LL
Lamp Included=
SCR
Aircraft Safety Cable-Housing to
Reflector
=
W/MWS
MWS Industrial components attached
to the fixture at the factory. (Standard
cord length is 3 ft. 6 ft. and 11 ft. also
available. Please refer to MWS
Modular Wiring System section for
additional information.
=
HC
LumaWatt Fixture Control Module
(Low voltage leads pulled out of
top connection box for areas
requiring all wiring to be installed in
conduit)
11, 13, 13
=
HL
LumaWatt Fixture Control Module
(Allows low voltage control wire to be
daisy-chained between fixtures outside
AC conduit run similar to low voltage
intercom's, fire alarms and phone
systems)
11
=
QLL
Quartz Lamp Included (Lamp is Cooper
designated product based on luminaire
requirements. Lamp is shipped separate
from luminaire unless otherewise noted)
=
Voltage
5
120V
208V
240V
277V
347V
480V
MT
6
TT
7
5T
8
Lamp Type
MP
Pulse Start Metal
Halide
1
=
MH
Metal Halide
1, 2
=
HP
High Pressure
Sodium
3
=
Reflector Type
ER
Enhanced Prismatic
Reflector
=
Reflector Diameter
22
22'' Diameter=
Series
SS
Steeler
=
Distribution
4
C
Concentrated
=
M
Medium
=
W
Wide
=
Socket
OR
Open Rated
Socket for
Metal Halide
Lamps
9
=
__
Non Applicable
(HPS or Not
compatible with
OR Socket)
=
1
Open Rated socket and lamp must be used.
Notes:
2
MH available in non-U.S. markets only.
3
Not available in 175, 320 and 350W.
4
Factory set for concentrated, medium or wide distributions otherwise fixture is shipped in medium setting.
5
Products also available in non-US voltages and 50HZ for international markets. Consult your Cooper
Representative for availabiltiy and ordering information. 88% Efficient EISA Compliant MP Fixtures not
available in 347V and TT Voltages.
6
Multi-Tap ballast 120/208/240/277V wired 277V.
7
Triple-Tap ballast 120/277/347V wired 347V.
8
5-Tap ballast 120/208/240/277/480V wired 277V. 400W Metal Halide only. 88% efficient EISA Compliant MP
fixtures not available in 5-Tap Voltages.
9
Not applicable for HPS.
10
Requires FH-1or FL-1or SHK.
11
30 second time delay when switching from bright to dim. Consult individual lamp manufacturers
recommendations for compatible lamps. For use with CWA ballast only.
12
Not available with HL or HC options.
13
Not available with PC3, C3, PHC or MWS. Not available with single circuit MWS special order.
14
Fixtures must be same wattage and voltage and without hooks, loops or plugs.
15
Specify L/TCB when using thru-way mounting box (TWMBS) accessory.
Specifications and
dimensions subject to
change without notice.
Eaton
1121 Highway 74 South
Peachtree City, GA 30269
P: 770-486-4800
www.eaton.com/lighting