Manual

VisionHDP™ User Manual and Installer Guide

Specifications

Inputs

• Eight standard inputs: Two composite, two SVideo, two SD/HD component/RGB and two

DVI-D/HDCP inputs.

• Two optional SDI inputs.

• Composite, SVideo and component inputs support NTSC (M, Japan, 4.43), PAL (B, D, G,

H, I, M, N, Nc) and SECAM (B, D, G, K, K1, L).

• Component input color-space can be selected as SDTV or HDTV.

• Absolute maximum rating is ±2 volts, referenced to case ground, for analog video inputs.

Processing

• Per-pixel motion adaptive deinterlacing and inverse-telecine for SD and HD sources.

• Proprietary scaling algorithms provide detail-enhancement.

• Adjustments for sizing, black-level, contrast, color, Hue, color/Hue offset, and Y/C delay.

• 11-point parametric grayscale and gamma calibration.

• Source aspect ratio selection of 4:3, 4:3 nonlinear-stretch, letterbox, 16:9 and 1.85.

• Supports two zoom steps for each source aspect ratio.

• Four independent configuration memories per input.

Output

• DVI-D/HDCP and analog output resolution from 480p to 1080p (VisionHDP), or to 800p

(VisionDVI), at up to 60 Hertz.

• The analog output supports RGB and YP

. Both formats support bilevel and trilevel

sync. RGB also supports discrete horizontal and vertical, or discrete composite, sync with

programmable polarities.

• YP

output color-space can be selected as SDTV or HDTV.

• For red, green, blue and Luma, the nominal output is 1.0 volts peak-to-peak with

embedded sync, and 0.7 volts otherwise. For P

and P

, the peak-to-peak is 0.7 volts,

including sync. Output levels are specified driving an external 75-ohm load.

• Discrete sync outputs drive TTL levels into an external 75 ohm load.

• Eight independent output configuration memories are supported.

• Resolution is programmable from 480p to 1080p in scanline increments, plus 1080i.

• Vertical refresh rate is programmable from 48 to 120 Hertz in steps of 0.01 Hertz. This

varies with resolution.

• Output aspect ratio is programmable from 1.33 to 2.35 in steps of 0.01.

• Output size and position are programmable in pixel increments.

Miscellaneous

• Menu based setup.

• Infrared remote or RS232 serial control interface.

• Dimensions: 12” (W) by 5” (D) by 3.5” (H).

• Power consumption: 25 watts nominal.

• The power supply input rating is from 100 to 240 volts at 47 to 63 Hertz.

• Silent operation (no fan).