Manual

VisionHDP™ User Manual and Installer Guide
© 2004-2007 Lumagen®, Inc. 31 Rev 1.14
OUT →
RES →
VRES Vertical active resolution
VRATE Vertical refresh rate
HRATE For analog output only: Horizontal rate (normally not used)
HRES For digital output only: Horizontal active resolution
TIMING Set output timing parameters in pixel increments
SIZE Set output size
POS Output position
ASPCT Output aspect ratio (1.33 to 2.35 in hundredths)
MISC →
GBAR →
SIDE Side gray-bar intensity (0 to 49 ire)
LBOX Top/bottom letter-box-bar intensity (Service mode only)
LEVL →
PDSTL Analog output black pedestal (0 IRE or 7.5 IRE)
DVILVL DVI-D output level (VIDEO or PC)
SHRINK Shrink any edge of the picture to fit in mask
SYNC →
DVI Select DVI output sync polarity (use direct command for analog out)
MODE → Single (default) or multiple-output-timing mode
SAME Single output configuration. All memories share output timing, etc.
INDEP Eight independent output configurations.
AUTOIND Automatically select output configuration for NTSC or PAL input.
COPY Copy current output configuration to selected output configuration(s)
MISC →
LCD → Visible for VisionHDQ only
BKLGHT LCD backlight enable
CNTRST LCD contrast
OSD Toggle OSD-enable. Shows status when input selected if enabled
LOCK Lock or unlock the configuration
POWR →
AUTO Unit can go to either “ON” or “STBY” when power is applied
MSG Change power-on on-screen message by following instructions
RS232 → Transmit message out RS232 serial port on power on or off
PWRON Power-on RS232 serial output message
PWROFF Power-off RS232 serial output message
BAUD Power on/off message BAUD rate
PAR Power on/off message parity
GAP Power on/off message character spacing
TPAT → Test and warm-up patterns
PATS Test patterns
WARMUP Warm-up patterns
SAVE → Note: Unsaved changes can be discarded by going to STBY
SAVE Save current configuration to flash ROM.
UNDO Toggle between current saved and previous saved configurations
RESTORE Restore from calibrator’s hidden configuration
FCTRY Reset to factory defaults