Manual

ManualsBrandsLumagen ManualsVideoVisionDVI & VisionHDP

VisionHDP™ User Manual and Installer Guide

l LBOX Input is 4:3 letter-box format (lower-case L). Use previous zoom setting

] LBOXNZ Input is 4:3 letter-box format (lower-case L) . No zoom

w 16:9 “Enhanced for 16:9 televisions” format. Use previous zoom setting

* 16:9NZ “Enhanced for 16:9 televisions” format. No zoom

j 1.85 Input is 1.85 format. Use previous zoom setting

/ 1.85NZ Input is 1.85 format. No zoom

W 2.35 Input is 2.35 format. Use previous zoom setting

a MEMA Select M EMA

b MEMB Select MEMB

c MENC Select MEMC

d MEND Select MEMD

g Onscreen messages on

s Onscreen messages off

z FREEZE Freeze-frame. Any other character resumes

Y YPRPB Output type is HD color-space YPRPB (component)

R RGBHV Output type is RGBHV. <enter> completes command

S RGBS Output type is RGBS. <enter> completes command

T RGsB Output type is RGsB. <enter> completes command

A 480P Select Vertical Resolution = 480p

B 540P Select Vertical Resolution = 540p

C 600P Select Vertical Resolution = 600p

D 720P Select Vertical Resolution = 720p

E 768P Select Vertical Resolution = 768p

F 840P Select Vertical Resolution = 840p

G 1080P Select Vertical Resolution = 1080p

I 1080I Select Vertical Resolution = 1080I

V VRES Set Vertical Resolution (e.g. V960 <enter>, for 960p)

~ VRATE Set Vertical rate (e.g. ~5994 <enter>, for 59.94 Hz)

H HRATE Set Horizontal Rate (e.g. H45000 <enter> for 45KHz)

= ASPECT Set Output aspect ratio (e.g. =178 <enter> for 16:9 displays)

tXMM

Test Pattern command: X is a letter ‘a’-‘p’ corresponding to the 16

available patterns. MM is the ire level divided by 10, so 0-10. Sending

‘X’ will exit the pattern display.

ZT1xxxx

Print a message on the screen for 5 seconds. The command always

begins with the characters "ZT", followed by a single digit which sets

the duration of the message. '0' for 2 seconds, '1' for 5 seconds, '2' for 10

seconds and so on, with '9' leaving the message onscreen until a "ZC" is

sent or a Lumagen remote control command clears the message. The

message string “xxxx” which follows the duration digit can be up to 30

characters in length. The '@' character font is replaced with a solid block

for use as a volume bar. Legal characters must be in the range of ' ' thru

'z' (which is 0x20 - 0x7a in hex). Anything outside that range such as

carriage return or even the '{' can be used to terminate the message

command.

ZC Clear any onscreen messages .

ZY0M

Set zoom factor to M. Where M can be 0-2, or 0-7 if zoom is set for 5%

steps.

ZY1MMM

Set output aspect ratio to MMM. Where valid range is 110-250 which

corresponds to 1.10 to 2.50.

ZY1MMMNNN

OOOPPP

Set output shrink parameters. Where MMM=top, NNN=left,

OOO=bottom, PPP=right edge. Range is 0-255 for each.