Manual

VisionHDP™ User Manual and Installer Guide

Serial RS232 Command Interface

The RS232 serial interface is used to enter commands using the same command format as the

infrared remote. The serial rate is 9600 BAUD with 8 data bits, no parity bit and one stop bit. No

hardware or software flow-control is used. The ASCII commands are:

ASCII Remote Function

% ON Power on

$ STBY Power to standby

M MENU Activate menu

X EXIT Exit. Often acts as a cancel key

! CLR Force menu off (e.g. can use to assure menu is off for input selection)

i INPUT Choose input (i.e. i2 <enter> for input 2)

P PREV Display previous input

k OK Accept command

<enter> Accept command (uses the PC “ENTER” keycode)

< … Left arrow (“less-than” key on keyboard)

> † Right arrow (“greater-than” key on keyboard)

v ˆ Down arrow (lower-case v, as in “vote”)

^ ‡ Up arrow (shift 6 key on keyboard)

0 - 9 0 - 9 Enter a digit 0 through 9

n 4:3 Input is 4:3 format. Use previous zoom setting

[ 4:3NZ Input is 4:3 format. No zoom