Manual

Section 10 – Command Interface

RadianceXS rev 091211

Section 10 – Command Interface

Direct Commands

Direct Commands are entered by using the Lumagen remote control or RS232 interface.

See Radiance Tech Tip 13 “Direct Commands and Menu Shortcuts” which contains a complete list

commands. This Tech Tip is available for download at

http://www.lumagen.com.

Output Vertical Resolution

480p: MENU 0 2 1 Progressive with 480 active scanlines

540p: MENU 0 2 2 Progressive with 540 active scanlines

720p: MENU 0 2 4 Progressive with 720 active scanlines

768p: MENU 0 2 5 Progressive with 768 active scanlines

1080p: MENU 0 2 7 Progressive with 1080 active scanlines

1080i: MENU 0 2 8 Interlaced with 1080 active scanlines

Output Mode Commands

Output 2D MENU 0 3 0 Set output mode to 2D

Output 3D-SBS MENU 0 3 1 Set output mode to 3D Side-By-Side

Output 3D-TB MENU 0 3 2 Set output mode to 3D Top-Bottom

Output Vertical Rate

Set vertical rate: MENU 0 4 (50Hz, 60Hz) OK

Output Aspect Ratio

Output aspect ratio: MENU 0 6 value OK Example: For 16:9 enter178

Miscellaneous Commands

S/W Rev MENU 0 9 0 3 Display software revision and serial-number

Menu timeout MENU 0 9 0 5 Toggle menu timeout. Short (default) or long (saved)

Service Mode MENU 0 9 1 0 Toggle SERVICE MODE. (not saved)

Reinterlace Off MENU 0 9 4 0 Turns reinterlacing off

Reinterlace On MENU 0 9 4 1 Turns reinterlacing on

Toggle field order MENU 0 9 4 2 Toggles field order for reinterlacing

Unlock menu MENU 0 9 1 5 Can also be selected using menu

Output defaults MENU 0 9 9 8 Reset current output to default for current resolution

Factory defaults MENU 0 9 9 9 Reset to factory default (Must “Save” to make permanent)

Menu Shortcuts

See Radiance Tech Tip 13 “Direct Commands and Menu Shortcuts” which contains a complete list

commands. This Tech Tip is available for download at

http://www.lumagen.com.

IR Command List

See Radiance Tech Tip 12 “IR Command Interface” which contains a complete list of IR commands.

This Tech Tip is available for download at

http://www.lumagen.com.

ASCII Command List

See Radiance Tech Tip 11 “RS232 Command Interface” which contains a complete list of RS232

commands. This Tech Tip is available for download at

http://www.lumagen.com.