Owner's manual
Table Of Contents
- LEGAL NOTICES:
- WARNINGS:
- Section 1 – Introduction
- Section 2 – Overview
- Section 3 – Quick Start Guide
- Section 4 – Basic Commands
- Section 5 – Video Configuration
- Section 6 – Audio Configuration
- Section 7 - Calibration
- Section 8 – Miscellaneous Commands
- Section 9 – 3D Support
- Section 10 – Darbee Visual Presence™
- Section 11 – Command Interface
- Section 12 – Specifications
Section 11 – Command Interface
Copyright 2009-2014 Lumagen, Inc. Radiance 2123 and 2143, Rev 041614
34
Section 11 – Command Interface
Direct Commands
Direct Commands are entered by using the Lumagen remote control or RS232 interface.
See Radiance Tech Tip 13 “Direct Commands and Menu Shortcuts” which contains a complete list
commands. This Tech Tip is available for download at http://www.lumagen.com.
Output Vertical Resolution
480p: MENU 0 2 1 Progressive with 480 active scanlines
540p: MENU 0 2 2 Progressive with 540 active scanlines
720p: MENU 0 2 4 Progressive with 720 active scanlines
768p: MENU 0 2 5 Progressive with 768 active scanlines
1080p: MENU 0 2 7 Progressive with 1080 active scanlines
1080i: MENU 0 2 8 Interlaced with 1080 active scanlines
Output Mode Commands
Output 2D MENU 0 3 0 Set output mode to 2D
Output 3D-SBS MENU 0 3 1 Set output mode to 3D Side-By-Side
Output 3D-TB MENU 0 3 2 Set output mode to 3D Top-Bottom
Output Vertical Rate
Set vertical rate: MENU 0 4 (50Hz, 60Hz) OK
Output Aspect Ratio
Output aspect ratio: MENU 0 6
value
OK Example: For 16:9 enter178
Miscellaneous Commands
Menu timeout MENU 0 9 0 5 Toggle menu timeout. Short (default) or long (saved)
Service Mode MENU 0 9 1 0 Toggle SERVICE MODE. (not saved)
Reinterlace Off MENU 0 9 4 0 Turns reinterlacing off
Reinterlace On MENU 0 9 4 1 Turns reinterlacing on
Toggle field order MENU 0 9 4 2 Toggles field order for reinterlacing
Unlock menu MENU 0 9 1 5 Can also be selected using menu
Output defaults MENU 0 9 9 8 Reset current output to default for current resolution
Factory defaults MENU 0 9 9 9 Reset to factory default (Must “Save” to make permanent)
Menu Shortcuts
See Radiance Tech Tip 13 “Direct Commands and Menu Shortcuts” which contains a complete list
commands. This Tech Tip is available for download at http://www.lumagen.com.
IR Command List
See Radiance Tech Tip 12 “IR Command Interface” which contains a complete list of IR commands.
This Tech Tip is available for download at http://www.lumagen.com.
ASCII Command List
See Radiance Tech Tip 11 “RS232 Command Interface” which contains a complete list of RS232
commands. This Tech Tip is available for download at http://www.lumagen.com.