Owner's manual
Table Of Contents
- LEGAL NOTICES:
- WARNINGS:
- Section 1 – Introduction
- Section 2 – Overview
- Section 3 – Quick Start Guide
- Section 4 – Basic Commands
- Section 5 – Video Configuration
- Section 6 – Audio Configuration
- Section 7 - Calibration
- Section 8 – Miscellaneous Commands
- Section 9 – 3D Support
- Section 10 – Darbee Visual Presence™
- Section 11 – Command Interface
- Section 12 – Specifications
Section 8 – Miscellaneous Commands
Copyright 2009-2014 Lumagen, Inc. Radiance 2123 and 2143, Rev 041614
28
Undo
Revert to the configuration over-written by the last SAVE command. Repeating the Save Undo command
toggles between the last two saved configurations. The command is:
MENU
→
Save
→
Undo
→
OK
Restore ISF calibration
During calibration, the video technician can save the resulting Lumagen configuration to a special hidden
configuration memory. This command restores that configuration in the event that the user inadvertently
changes the configuration. A SAVE is required to make the restore permanent. The command is:
MENU
→
Save
→
Restore ISF
→
OK
Revert To Factory Settings
Set all parameters to factory defaults. A SAVE is required to make the settings permanent. The command
is:
MENU 0 9 9 9
Or MENU
→
Save
→
FactoryReset
→
OK