Installation Guide

6 | LulzBot Mini 2 ABS+ Enclosure Instructions
9
10
Proper Use
If you do crack a panel please contact [e-mail] or call 1-970-377-1111 for assistance.
Questions or issues?
Please contact [e-mail]
or call 1-970-377-1111 for assistance.
This work is licensed under a Creative Commons Attribution - ShareAlike 4.0 International License.
Created by David Randolph & Printed Solid .
6 6
Step 12:
While not needed we have included the optional plate cover (Part H) that sets in place to help cover
the top. During our testing we saw no significant air flow or temperature differences in the printer with the
optional top on or off. When using larger dimension spools of filament, removing the optional top cover can
help prevent unnecessary drag. On some Mini's you may notice a slight lift of the optional plate cover when at
max Z travel. This is normal and will not cause any damage to the printer.
Proper Usage:
Questions or issues?
Congratulations on a job well done!
6 6
Step 12:
Proper Usage:
You can lift the front or back up and off the 3D printed post. The cutout on the bottom helps to clear
the arms on the bed of the printer. It is normal for the cover to sit on the table and is part of the design to help
reduce the risk of accidental breakage of the top plates. You will also notice the post holes are slightly
enlarged and the front/back covers are slightly larger than the top and side covers. This is intentional to help
prevent accidental snags or breakage after repeated use.
Questions or issues?
Congratulations on a job well done!