Installation Guide

2 | LulzBot Mini 2 ABS+ Enclosure Instructions
a
What’s Inlcuded?
If you do crack a panel please contact [e-mail] or call 1-970-377-1111 for assistance.
The enclosure is made from cast acrylic for optical clarity that helps reduce visual distortions. Do not use
household cleaners to clean the Acrylic. Use dish soap or hand wash and do not scrub or use any abrasives.
If you do crack a panel please contact [e-mail] or call 1-970-377-1111 for assistance.
Questions or issues?
Please contact [e-mail]
or call 1-970-377-1111 for assistance.
2 6
What’s Included?
2 Part A: Front and rear panel
2 Part B: ABS Rear cover sides
1 Part C: ABS Rear cover top
1 Part D: ABS Rear cover bottom
2 Part E: ABS Front cover sides
1 Part F: ABS Front cover top
1 Part G: ABS Front cover bottom
1 Part H: Optional top insert
1 Part I: ABS Short side cover
1 Part J: Long side cover
1 Part K: ABS Top cover
36 M3-10mm bolts
8 M3-40mm bolts
36 M3 square nuts
2 M3 washers
4 3D Printed brackets
1 GLCD 3D Printed bracket
Tools Needed
2mm hex driver
2.5mm hex driver
Optional: Painters tape
Optional: Flat razor
Time Required
1-2 hours based on skill level
You can crack the acrylic very easily by over tightening.
Do not over tighten the screws. Tighten them just enough to hold without moving around.
If you do crack a panel please contact [e-mail] or call 1-970-377-1111 for assistance.
Questions or issues?
32 M3-12mm bolts
8 M3-40mm bolts
31 M3 square nuts
13 M3 washers
4 3D printed brackets