L UL ZBO T ® AND MODELS ABS+ ENCLOSURE ASSEMBLY INSTRUCTIONS V. 29 March 2021 This work is licensed under a Creative Commons Attribution - ShareAlike 4.0 International License. Created by David Randolph & Printed Solid.
a What’s Inlcuded? What’s Included? 2 2 1 1 2 1 1 1 Part A: Front and rear panel Part B: ABS Rear cover sides Part C: ABS Rear cover top Part D: ABS Rear cover bottom Part E: ABS Front cover sides Part F: ABS Front cover top Part G: ABS Front cover bottom Part H: Optional top insert 1 1 1 36 32 8 31 36 213 44 1 Part I: ABS Short side cover Part J: Long side cover Part K: ABS Top cover M3-10mm bolts M3-12mm bolts M3-40mm bolts M3 square nuts M3 square nuts M3 washers M3 washers 3D Printed printed bracke
1: 1Step Step 1: Install the brackets on the front and rear of the printer. Using a 2mm hex driver to remove the existing Step 1:install the brackets using the included M3-40mm bolts and a 2.5mm hex driver. While there is still screws and support for the top of the printer with the screws removed it is recommended to do one bracket at a time.
Step 4: Step short side4: cover (Part I) on the left side of the printer by inserting the tabs into the slot on the top cover. Make If you have an LCD screen on your Mini remove the screw in the picture below then set the black ABS sure that the vent holes are towards the front of the printer. The square nut sits in the slot and the 2 M310mm 12mm bolt goes through the top cover into the square nut.
6Step 7: Using 2 M3-10mm 12mm bolts, square nuts and washer you can insert these from the outside with the nut and washer on the inside of the 2 diagonal slots at the bottom of the long side cover (Part J). The washer and nut help to hold the lower portion on the frame of the printer. Step 7: Step 7: Step 7: Step 9: 7Step 9: Take the black ABS front top cover with textured side up (Part F) and connect the 2 black ABS front side 12mm bolts and M3 square nuts.
9Step 12: While not needed we have included the optional plate cover (Part H) that sets in place to help cover the top. During our testing we saw no significant air flow or temperature differences in the printer with the optional top on or off. When using larger dimension spools of filament, removing the optional top cover can help prevent unnecessary drag. On some Mini's you may notice a slight lift of the optional plate cover when at max Z travel.
