Service Manual User guide

9.161
Model 644E-42/944E-42 Rev. 6/04
Electrical System
9.10.13 Stabil-TRAK™ “Slow Pivot” Mode Indicator Troubleshooting
0000000
RPM X 100
5
10
15
30
20
25
F
1/2
E
104
176
80
248
120
°C
°F
r/min
D
Replace fuse and
troubleshoot
harness.
Replace boom
sensor switch.
Not OKIf OK
Adjust switch to
acquire gap.
Verify power at
boom sensor switch.
Not OKIf OK
Stabil-TRAK™ indicator
stays ON with boom
below 40°.
MU4360
Check boom sensor
connections.
Stabil-TRAK™
“Slow Pivot” Mode
Indicator
Repair connections
as needed.
Check if boom sensor
LED is ON.
If OK
Check boom sensor to
boom gap is
.12" to .19" (3 to 5 mm).
Verify that stability brake
switch contacts are open
with pedal released.
If OK
Troubleshoot
harness for short to
B+ in slow pivot
circuit. Check wires
[S11] (ORG/WHT),
[S11A] (ORG/WHT),
[S11B] (ORG/WHT),
[S10] (ORG/WHT),
[S10A] (ORG/WHT),
[S10B] (ORG/WHT),
[S10C] (ORG/WHT)
and [S9] (LT BLU).
Replace boom
switch relay.
Not OKIf OK
Not
OK
Not
OK
Unplug boom switch
relay and indicator light
should go OFF.
If OK
Not
OK
Replace switch.
Not OK
Adjust switch. Refer
to page 9.244
Before troubleshooting any
electrical circuit, ALWAYS begin
by checking the following:
1. Fuses.
2. Battery for proper charge.
3. All connections relating to
circuit are clean and tight.
4. All grounding straps are intact
and securely fastened, refer to
Section 9.1.12, “General
Overview (Vehicle Ground
Strap Locations).”
5. Check dash panel bulbs for
proper function.