Owner's manual

Operation

Model 644E Rev. 8/03

Numerous attachments, marketed by OmniQuip are available for this vehicle. The

capacity charts attached to this vehicles dash are to be used with OmniQuip

approved attachments only. Hydraulically powered attachments must only be used

on vehicles equipped with auxiliary hydraulics.

IMPORTANT! This vehicle is intended for the function of lifting only. This vehicle is

not designed to PULL, TOW or DRAG other objects.

OmniQuip makes no representations or warranties, expressed or implied, as to the

design, manufacture or fitness for use with this vehicle of any third party source

attachment. This vehicle is not intended to be used and should not be used with an

attachment that would alter the center of gravity or stability of this vehicle.

OmniQuip assumes no liability for any third party attachment that would alter the

center of gravity or stability.

IMPORTANT! DO NOT use unapproved attachments.

Following is a list of some of the attachments available through OmniQuip for this

vehicle model:

• 48" Standard Carriage

• 48" Side Tilt Carriage

• 50" Standard Carriage

• 50" Side Tilt Carriage

• 60" Standard Carriage

• 60" Side Tilt Carriage

• 72" Framers Carriage

• 72" Framers Tilt Carriage

• Single Fork Positioning Carriage

• Dual Fork Positioning Carriage

• 1-1/4 Cubic Yard Bucket

• Auger Attachment

• Sweeper Attachment

• .5 Cubic Yard Concrete Hopper

The standard capacity chart, as shown in the last section of this manual, is

applicable for the above listed attachments.

Using Other Attachments