Service Manual User guide

Boom and Transfer
6-82 31200079
a. Remove two (2) each nuts (Item 7), lockwashers (Item 8), and tube
clamps (Item 9) securing each set of auxiliary and carriage tilt
hydraulic tubes (Items 5 and 6) to bottom of middle (rear) boom
section.
b. Loosen screw on cushion clamps (Item 10). Slide cushion clamps
out of channel and remove hydraulic tubes from boom section.
Fig. 6-88: Side Slide Pads – Outer Boom Section
41. (Ref. Fig. 6-88) Remove side slide pads from outer boom section as
follows:
a. Remove four (4) capscrews (Item 1) and lockwashers (Item 2)
securing side slide pads to outer boom.
b. Remove the two (2) slide pads (Item 4) and shims (Item 3).
J1237
# Description
1 Button-Head Socket Capscrew
2 Lockwasher
# Description
3Shim
4 Side Slide Pad
4
3
1
2