Instruction Manual

14
5. The unit is now operational. To use it, place it on a suitable, level site!
WARNING / CAUTION / ATTENTION!
Observe the following:
• Remove easily  ammable or other hazardous material from the surroundings
of the unit!
• Install the unit at least 1 m (39.4 in.) away from walls or other structures!
• Operate the unit only in a dry, well-ventilated area!
• Ensure than no foreign objects can enter the exhaust pipe!
• Do not bring naked flames in the vicinity of the unit! Do not smoke!
• Install the unit on a flat, stable surface!
• Do not block any air ducts of the unit with paper or other material!
8. Operation
Before starting the motor, perform all instructions from the chapter "Commissioning".
Flow chart for starting:
1. Check that all maintenance openings (side parts etc.) are connected to the unit; if not,
close them immediately.
2. Check that the valve switches are set to "0".
8.1 Starting motors
Valve switchValve switch
6. Finally, you can connect the extension hoses and/or hose reels (as described in the
chapter "Connection of the hose lines").