Instruction Manual

38
A
B
C
4. Re¿ t components "A" and "C" in the reverse order.
5. Fill fresh hydraulic À uid into the reservoir through the ¿ ller neck and then close off the
neck with ¿ ll cap "B".
6. Finally, the unit must be vented as described in the chapter entitled "Start-up".
Procedure:
1. Place the unit on a slightly raised base so that the drain screw for the hydraulic À uid is
easy to access.
2. Place a suitable container under drain screw "A".
3. Open ¿ ll cap "B", remove drain screw "A" and seal ring "C", and allow the hydraulic À uid
to drain into the container provided.
11.2.4 Replacing signs
All damaged and/or illegible signs (safety notices, type plate etc.) must be replaced.
Procedure:
1. Remove damaged and/or illegible labels.
2. Clean surfaces with industrial alcohol.
3. Af¿ x new signs.
Ensure that you attach the signs in the correct position. If this is no longer known, you should
ask your authorised LUKAS dealer or contact LUKAS directly.