User's Manual

uBoard Hardware Installation Guide (V2.2)
PenAndFree Co.,Ltd, 2010 3
1. Verify Components before Installation.
Before hardware installation, firstly, please check if components listed below are
included in the package. If you find missed one, please contact the store you purchased.
.
Item Quantity Remarks
1
Station
1
2
Digital Pen
1
3
Recharging battery Cable
1
1M
5
Software CD
1
Including Calibration & Board SW
6
Station Holer
3
2. Station Installation.
2.1 Connecting USB Cables properly.
2.1.1 Connect Micro USB connector to Micro USB port of Station.
Connects USB cable to micro USB port of uBoard station and adhere station holder to
whiteboard or flat surface.
 Attach Station holder to the backside of station. As magnet is included in the back side of
station, it can be easily attached.
 Connect micro USB connector of USB cable to micro USB port of Station.
 Take off masking tape of station holder.
 Place Station in the middle of whiteboard or working area and press Station to adhere
station holder.
 Make sure station position with screen without tilting vertically.