User's Manual

uBoard Hardware Installation Guide (V2.2)
4
2.1.2 Connect USB connector to USB port of Computer.
Connect USB connector, the other end of USB cable, to the USB port on the computer.
If cable length is not enough, please use USB extension cable.
2.2 Connecting VGA cable properly.
After connecting USB cable between uBoard station and computer, connect VGA cable
between Beam project and the computer. It is the last step for hardware installation. When
this step is completed successfully, you are ready to use uBoard in hardware side.
However, in order to use uBoard, Software installation is additionally required.
As for SW installation, Please refer to the software installation guide.