User's Manual

uBoard Installation Guide (V4.1)
10 |
P a g e
2. Install uBoard Station.
Before using uBoard system, uBoard station needs to be mounted properly on the
surface. Therefore, please read this section carefully and follow each step stated
below.
① Connect the Beam projector and the computer with RGB cable after turning
on the computer and the beam projector.
② Set the computer to the duplicate window mode to
display the window on both the computer screen and
the projected screen thru the projector.
(In general, F4 key functions the window mode
change. If it doesn’t work properly, please refer to the
computer manual.)
③ Adjust the projected screen size and align the focus .
④ Connect the micro USB connector of USB cable to
the micro USB port of the uBoard Station.
[For wireless model, skip this step.]
⑤ Place the station holder to the backside of the station. As the magnet is
included in the station, the holder can be easily
attached to the station.
⑥ Peel masking tape off from the station holder.
⑦ Place the station on the left side from the projected screen. When placing the
station, please keep it centered vertically in parallel to
the whiteboard frame.
Note :
When to place the station on the left side, maintain
minimum 3 cm space between the station and the
projected screen. But when to place it on the upper
side, keep 5 cm distance at least between them.