User manual

EN Operating manual – temperature measuring device XP100 / XP101 15
11_2014
For maintenance or repair work which requires the
housing to be opened, contact Lufft
®
customer
service. Devices which have been opened
unlawfully are void of any warranty and warranty
claims.
Cleaning the device
1. Use a soft, lint-free cloth for cleaning.
2. Dampen the cloth with clean water. Do not use sprays,
solvents, alcohol-based or abrasive cleaners to dampen the
cloth.
3. Remove dirt from the housing, the connections and the
display.
Battery change
Change the batteries when the message Batt lo is displayed upon
switch-on or the device can no longer be switched on. See
Inserting the batteries on page 5.
An overview of the currently available PT100 sensors is provided
below.
Further details about PT100 sensors and their use is provided in
the separate general catalogue.
Note!
Lufft
®
continually improves and broadens the range of available
sensors. Information on additional, new sensors can be found on
the website www.lufft.de.
Maintenance
Available PT100 sensors
PT100 sensor
Article num-
ber
Compatible
with
XP100 XP101
Immersion probe, short 3120.520 X X
Immersion probe, long 3120.530 X X
Immersion/penetration probe, long 3120.540 X X
Stainless steel food penetration probe 3120.550 X X
Immersion probe for XP100 3120.560 X
Surface probe 3120.600 X X
Precision ceramic probe for XP101 3120.700 X
3120.
540
3120.
700
3120.
520
3120.
530
3120.
600