User manual

EN Operating manual – temperature measuring device XP100 / XP101 13

11_2014

Carrying out a measurement

Note:

Note that moving from a cold area to a warm area can lead to

condensation forming on the device's circuit board. This physical

and unavoidable effect can falsify the measurement. In this case,

the colour display shows either no measured values or they are

incorrect. Wait a few minutes until the device has become

adjusted to the changed conditions before carrying out a

measurement.

Upon connection of a sensor the devices changes into the

measuring mode. The corresponding screen is displayed and the

measurement begins.

Shut down procedure

1. Use the On/Off key (9) to switch the device off.

2. Detach connecting cables and sensors.

3. Clean the device according to the chapter Cleaning the

device.

4. Store the device according to the chapter Storage.