User manual

EN Operating manual – temperature measuring device XP100 / XP101 9
11_2014
Settings screen
You can configure the device as follows in the Settings screen:
Settings 1/3:
Settings 2/3:
16
28
29
30
31
16 Selects the screen language (see chapter Set language).
28 Selects the unit system:
Metric: Activates the metric unit system for all available meas-
ured values (e.g. for use in continental Europe).
Imperial: Activates the imperial unit system for all available
measured values (e.g. for use in the USA).
29 Sets the screen brightness.
This option can only be selected by using the cross control below the
colour display.
1. Repeatedly press the Down key on the cross control until the scale is
selected.
2. Press the Left or Right keys on the cross control to reduce (left) or
increase (right) the screen brightness.
30 Sets the date and time.
This option can only be selected by using the cross control below the
colour display.
1. Press the Down key on the cross control until the date is selected.
2. Press the OK button on the cross control.
 The entire row is selected.
3. Press the Left or Right keys on the cross control to select the value to
be configured.
4. Press the Up or Down keys on the cross control to increase or reduce
the value to be configured.
5. Press the OK button on the cross control.
 The row is deselected.
31 Opens the next screen.
32
33
34
35
32 Either specifies the period for automatic dimming of the colour display
or deactivates the function:
30 seconds, 1 minute, 5 minutes, off
33 Either specifies the period for automatic switch-off of the colour display
or deactivates the function:
10 minutes, 30 minutes, 1 hour, off
Note!
This function is deactivated during an automatic measurement.
34 Switches signal tones/key tones on or off.
35 Opens the next screen.