Operating Instructions

Table Of Contents

Operation

5 - 24

LUDWIG HOOK / 06/10/2020 / Ludwig System GmbH & Co KG; 83435 Bad Reichenhall, Germany / Tel.: +49 8651 7656730

5.9 After finishing work

5.9.1 Carry out suspended from the crane

The following steps must be taken at break times and after finishing work:

• Open LUDWIG HOOK by radio. No power is consumed in this condition

and the service life of the battery will be increased considerably!

• If necessary, remove the LUDWIG HOOK and load at the loading station!

• Clean LUDWIG HOOK and spray locking pin with WD 40!

5.9.2 In extreme weather

Extremely cold temperatures will reduce the service life of the batteries.

• Open LUDWIG HOOK by radio.

• Remove LUDWIG HOOK from crane or load slinging equipment.

• Clean LUDWIG HOOK and spray locking pin with WD 40.

• Store LUDWIG HOOK and radio remote control in a heated room.

5.10 Storage

HINWEIS

NOTICE

Storage.

Measure:

• Before storage: LUDWIG HOOK and fully

charge remote control! Storage in the

discharged state can lead to damage to the

batteries.

• If the LUDWIG HOOK is stored under tension,

there is a danger of deep discharge of the

batteries.

• The batteries must be charged every 4 months

with long periods on non-use.