Installation Guide

Product Information | 9
VI. ADDITIONAL INSTALLATION RULES
• Use permanent 100% silicone caulk next to
bathtubs, showers, sliding doors or similar
areas
• For bathroom installations, it is not necessary
to remove the toilet. Make relief cuts around
the perimeter of the toilet and make sure the
vinyl ooring is laying at before trimming off
the excess material.
• Note: if there is ceramic sanitary cove and
no place to install trim mold, you can apply
caulk around the walls.
• Floor covering subjected to excessive heat
and light is subject to thermal degradation.
Use appropriate precautions to minimize
potential effects on the oor covering.
• Never use tape around the perimeter of the
room.
• Do not place heavy items on newly installed
oor covering for at least 24 hours after
completion of the installation.
• For Metal door jambs that cannot be
undercut, leave an 1/8” expansion gap and
caulk with 100% silicone caulking.
• Do not use tape to secure oor protection
during construction or renovation. Use ram
board or similar to protect the oor.
• DO NOT slide heavy appliances or furniture
over or across the ooring. Always lift objects
and place them on the ooring or reposition
appliances and furniture using professional
moving glides or carpet with the pile side down.