Owner's Manual
OWNER'S MANUAL
18
PROBLEM POSSIBLE SOLUTION
No features of the base will activate. Ensure the remote is paired correctly with the
base (see page 15).
Unplug the power cord, wait 30 seconds and
plug back in to reset electric components.
The surge protection or the electrical outlet
may be defective. Test the outlet by plugging
in another working appliance.
Head or foot section will elevate, but will
not return to the at position.
Bed mechanism may be obstructed.
Elevate bed and check for obstruction.
Remove obstruction.
Head section may be too close to the wall.
Head and Foot lift function has minor
interference during operation.
Check batteries in wireless remote control.
Replace with three new AAA batteries
if necessary.
Make sure that you are following the duty
cycle of the motors (do not operate more
than two minutes over an 18 minute period.
Wireless remote may be experiencing
common radio frequency interference from
other radio transmitting devices. Wait several
seconds and try pressing appropriate button
again. See FCC Compliance Statement (page 5).
Base has lost power and will not lower. Refer to remote lock guide (see page 12).
Troubleshooting