Use and Care Manual

ADVANCED ADJUSTABLE BASE
17
PROBLEM POSSIBLE SOLUTION
No features of the base will activate. Ensure the remote is paired correctly with the
base (see page 14).
Unplug the power cord, wait 30 seconds and
plug back in to reset electric components.
The surge protection or the electrical outlet
may be defective. Test the outlet by plugging
in another working appliance.
Head or foot section will elevate, but will
not return to the at position.
Bed mechanism may be obstructed. Elevate
bed and check for obstruction. Remove
obstruction.
Head section may be too close to the wall.
Head and Foot lift function has minor
interference during operation.
Check batteries in wireless remote control.
Replace with two new AAA batteries if
necessary.
Make sure that you are following the duty
cycle of the motors (do not operate more
than two minutes over an 18 minute period.
Wireless remote may be experiencing
common radio frequency interference from
other radio transmitting devices. Wait several
seconds and try pressing appropriate button
again. See FCC Compliance Statement (page 5).
Troubleshooting